What the FunnyPlaying M2 Kit Offers
The FunnyPlaying 3.0 Inch M2 IPS LCD Backlight Kit for GBA SP replaces the original screen with a modern laminated display. It delivers enhanced brightness, color, and clarity while fitting inside original OEM shells and most aftermarket shells. The kit includes a pre-adhered glass lens with holographic logo text, so no separate lens purchase is needed.
Kit Specifications and Features
- Game Boy Advance SP 3.0 Inch M2 IPS LCD Backlight Kit - FunnyPlaying: OSD menu with 8 brightness levels (BRT), 5 color options (CLR), 3 display options (DSP), frame blending on/off (FRM), and color gamut (CG). You can fine-tune the display to match your preference without external tools.

Game Boy Advance SP 3.0 Inch M2 IPS LCD Backlight Kit - FunnyPlaying - Game Boy Advance SP 3.0 Inch M2 IPS LCD Backlight Kit - FunnyPlaying: Touch sensor on the ribbon cable allows short press brightness adjustment and long press OSD menu access. Brightness control is built into the ribbon, so soldering is optional — only needed if you prefer using the traditional brightness button.
- Game Boy Advance SP 3.0 Inch M2 IPS LCD Backlight Kit - FunnyPlaying: Available in 10 colors: Black, White, Silver, Blue, Baby Blue, Yellow, Green, Orange, Pink, Purple. You can match the kit's lens color to your shell for a cohesive look.
Installation Steps
Always perform a dry run before final installation to confirm the kit works. A dry run means testing the LCD outside the shell with all connections made but not mounted. If you are unsure how to do this, contact support.
- 1. Dry Run the Kit: Connect the ribbon cable to the GBA SP motherboard, attach the LCD, and power on the console. Test that the display lights up and responds to the touch sensor. Do this without placing the LCD inside the shell.
- 2. Prepare the Shell: If using a FunnyPlaying Mirror Clear ITA/IPS shell, note that the bracket is not included with this kit. You may need foam backing (sold separately) to secure the LCD. For other shells, the kit fits without a bracket.
- 3. Install the LCD: Carefully place the LCD into the shell. Do not remove the pre-adhered lens — doing so can damage the LCD and void the warranty. Do not place an extra lens on top.
- 4. Connect and Route Cables: Connect the ribbon cable to the motherboard. Route the touch sensor wire so it is accessible. Ensure all ribbon cables have no bends or creases.
- 5. Test and Adjust: Power on the GBA SP. Use the touch sensor: short press for brightness, long press (3–5 seconds) to open the OSD menu. Long press again to switch menu options, tap to adjust. The OSD closes automatically after 5 seconds of inactivity.
- 6. Final Assembly: Once everything works, close the shell. If you used foam, ensure it is placed correctly. Backlight kits that have been installed are not eligible for return, so test thoroughly before finalizing.
Compatibility and Trade-offs
The M2 kit fits original OEM shells and most aftermarket shells, including IPS-ready ones. However, for FunnyPlaying Mirror Clear ITA/IPS shells, you must purchase foam separately because the bracket is not included. The foam acts as a spacer to hold the LCD securely.
Soldering is optional — only required if you want to use the GBA SP's original brightness button instead of the touch sensor. If you choose to solder, it voids the warranty on the kit. The touch sensor method is simpler and recommended for most users.
Important Warnings
Do not remove the pre-adhered lens from the LCD. Attempting to do so can break the LCD and voids the warranty. Similarly, using adhesives, brackets, or soldering (except for the brightness button) will void coverage.
LCD panels are fragile and can break if dropped or pressed too hard. Handle with care during installation. Always test the kit before mounting it in the shell to avoid damage that is not covered by returns.


