PS5 TMR Joystick Tension Adjustment Guide

Quick answer

Adjust the tension on your Gulikit TMR joystick by rotating the metal ring around the joystick base. A full 720° rotation lets you fine-tune resistance from very light to firm, matching your preferred feel.

Step-by-step tension adjustment

1. Install the TMR joystick: Solder the Gulikit TMR joystick onto your PS5 DualSense or Edge controller board, following the manufacturer's wiring diagram. Ensure all solder joints are clean and no bridges exist. Common mistake: reusing old joystick caps that may not fit the TMR shaft. Use the included cap or a compatible third-party cap.
2. Locate the tension ring: The silver or black metal ring sits at the base of the joystick module, just above the controller board. It has small notches for grip. Checkpoint: the ring should rotate freely. If it feels stuck, do not force it—verify the joystick is fully seated in the controller shell.
3. Adjust tension clockwise for firmer feel: Turn the ring clockwise (as viewed from above) in 90° increments. Each quarter turn increases resistance noticeably. A full 720° (two full rotations) gives maximum tension. Common mistake: overtightening past 720° can damage the internal mechanism. Stop at the firmest setting you prefer.
4. Adjust tension counterclockwise for lighter feel: Turn the ring counterclockwise to reduce resistance. Start from the factory midpoint and go in 90° steps until the stick moves freely without wobble. Checkpoint: if the stick feels loose or has play, you have gone too far. Return clockwise until the play disappears.
5. Calibrate the joystick: On PS5, go to Settings > Accessories > Controllers > Calibrate. Follow on-screen prompts to center the stick. On PC, use the Gulikit calibration tool or Steam's controller settings. Common mistake: skipping calibration after tension change can cause off-center drift. Always recalibrate, even if the stick feels centered.
6. Test in game: Launch a game with precise aiming or steering (e.g., a shooter or racing title). Verify that the stick returns to center and that your inputs feel consistent. Checkpoint: if you notice uneven resistance or sticking, recheck the ring position and calibration. Repeat steps 3–5 as needed.

Product used in this guide

• 720° Tension Adjustable TMR Joystick for PS5 and Edge Controller - Gulikit: Gulikit TMR Electromagnetic Joysticks eliminate stick drift and feature a 720° range of adjustable tension. You can customize the stick resistance from very light to firm without replacing springs, and the electromagnetic design prevents the wear that causes drift in traditional potentiometer sticks.